The print and the lamination over it are great. Much better than the stock Arcade1UP panel, and no plexi required. However, the two rear corners were not adhered properly to the plywood, and the overlay lifted slightly while I was putting the control panel into place. Also, the joystick hole is not centered in the middle of the print for the directional arrows (you can even see this in the example image for the item here on the website). This is the same issue I noticed on my Marvel Super Heroes panel I bought here a few months ago, except in that case it was the button holes that weren't aligned properly with the print. For items costing $60-70, a little more precision would be appreciated.